Rough-in plumbing
We install supply, drain, waste and vent piping to the fixture layout at correct sizes and slope, set and ready for inspection before insulation and drywall close the walls in.
No rel=preload for this sheet: the preload scanner discovers a
stylesheet in the same pass it would discover the preload hint, so the hint is a no-op that just adds a byte cost. #} Skip to contentRemodel and new construction plumbing covers the rough-in stage, meaning supply, drain, waste and vent piping installed before walls close, and the finish stage of setting fixtures and trim, for kitchens, bathrooms, additions and new homes.
Remodel plumbing runs on the same clock as everything else on the job. Rough-in has to be complete, inspected and correct before drywall goes up, because every fixture location, drain slope and vent connection is fixed at that point. Moving a toilet three feet after the fact means opening a slab. Getting the layout right on paper, and roughed to code the first time, is what keeps a remodel on schedule.
New construction and additions offer more freedom but demand the same discipline: correctly sized supply lines, properly pitched waste lines, venting that meets code, and a plan that anticipates the fixtures actually going in. Renovation work adds one more complication, because you are tying new plumbing into whatever the house already has, which in older Brandon homes may be cast iron drains or galvanized supply that will not tolerate being disturbed.
We install supply, drain, waste and vent piping to the fixture layout at correct sizes and slope, set and ready for inspection before insulation and drywall close the walls in.
Once surfaces are done we set toilets, sinks, faucets, tubs, showers, valves and trim, connect appliances, and test every fixture and connection under working pressure.
We relocate sink and dishwasher connections, run supply and drain to islands and peninsulas, add pot fillers or filtered water lines, and handle disposal and appliance hookups.
We reconfigure drains and supply for new layouts, set shower pans and mixing valves, handle tub-to-shower conversions, and install accessible or curbless configurations where the framing allows.
We plumb new bathrooms, laundries, kitchens and whole houses from the ground up, coordinating with the slab pour or floor framing and with the general contractor's schedule.
As a Florida certified plumbing contractor we pull the required permits, build to current Florida Building Code, and coordinate rough and final inspections with the authority having jurisdiction.
We review drawings or walk the space, confirm fixture locations against real rough-in dimensions, and flag anything in the existing plumbing that will constrain the design before demolition starts.
We install the supply, drain, waste and vent system to the approved layout, pressure test it, and get it inspected before any of it is covered up.
After tile, counters and cabinets are in, we return to set and connect every fixture, adjust valve depths and escutcheons, and test each connection for leaks.
We complete the final inspection, verify operation at every fixture and shutoff, and walk you through the system so you know what was installed and where the isolation valves are.
Nearly all Brandon housing is slab-on-grade, which means drain relocations in a remodel usually involve cutting and re-pouring concrete rather than working from a crawlspace. That single reality drives most layout decisions here. Hillsborough County also requires permitting and inspection for plumbing alterations, and older Brandon homes frequently need existing cast iron drain sections replaced where the new work ties in.
Install and repair faucets, toilets, disposals and water fixtures.
Learn moreWhole-home repipes in PEX or copper, plus fast burst-pipe repairs.
Learn moreTank & tankless repair, replacement and upgrades — hot water back fast.
Learn moreLicensed, insured and local — serving Brandon and Greater Tampa Bay.